• 23Mar

    TunerCode Overview…

    Uncategorized Comments Off

    TunerCode is custom ECU firmware for enhanced functionality of stock ECUs. Currently supported Nissan ECUs are listed on the About page. TunerCode currently does not support automatic transmissions, and is for off-road use only.

    TunerCode V5 Standard Features:

    • High RPM tuning limit (8012.5 rpm) removed.
    • Choice of soft cut or hard cut rev limits.
    • Launch Control.
    • Overboost rev limiter.
    • Soft cut Speed Limit (Can be disabled or set for valet mode)
    • Injector Size parameter.
    • Uses only one fuel map.
    • Uses only one timing map.
    • Uses only one CLT enrichment table.
    • Enable/Disable Knock Analysis
    • Enable/Disable Closed Loop O2 Analysis
    • Enable/Disable Long Term Fuel Trim (self-learn)
    • Enable/Disable TPS fuel map load column contol
    • Enable/Disable EGR
    • Enable/Disable AIV
    • Enable/Disable O2 Sensor Heater
    • Enable/Disable A/C Compressor
    • Programmable A/C Compressor control
    • Programmable Radiator Fan control.
    • Enhanced Data Logging
    1. Logging of all sensor data, fueling and timing parameters, knock, idle, and status information.
    2. Map/Table Tracing for fuel and timing maps and all other tables.
    3. Programmable Data Monitor Graphs
    4. Programmable History Tables (Predefined knock, O2 sensor and MAF sensor tables)
    5. Diagnostics Dash for TPS, idle, and timing adjustment
    • Tuning Tables/Parameters for:
    1. Fuel/Timing Maps and Tables
    2. Knock Control
    3. Dwell
    4. Startup fuel/timing
    5. Accel Enrichment
    6. TPS Enrichment
    7. CLT Enrichment
    8. Decel Fuel Reduction
    9. Idle fuel/timing
    10. Fuel Cut control

    New TunerCode V5 Features:

    • Spark cut limiting, in addition to fuel cut limiting.
    • Set Launch, uses throttle, tach, and gear shift to set launch rev limit
    • Programmable Outputs (for VVL, NOx, Fans, etc.)